Hand Made Strap
Shell Cordovan Leather Watch Strap – Black
$129,99
Need help measuring? Open the sizing guide
1. Find your watch's lug width
The lug width is the gap between the two lugs where the strap attaches. Most watches list this in their specs — common sizes are 18mm, 20mm, and 22mm.
If your watch isn't listed: measure the gap with a millimetre ruler, or note the existing strap's width near the spring bars. Round to the nearest whole millimetre.
2. Measure your wrist
Wrap a piece of string, ribbon, or paper strip around your wrist where the watch sits. Mark where the end overlaps. Lay it flat and measure the marked length in cm or inches.
Tip: Measure with a comfortable fit — not too tight. The strap will sit at this length, with the buckle on the underside of your wrist.
3. Find your strap length
Each strap length on this product is shown as two numbers, e.g. 75/115mm: the buckle-side cut and the tail-side cut, both measured from the watch lugs. Use the calculator below to find your size — it reads the actual sizes available for this strap and recommends the closest match.
Calculate your strap length
Enter your wrist size and your watch's lug-to-lug distance — we'll recommend the matching strap length and you can apply it with one click.
This is a recommendation only. Custom straps are not fully refundable. To protect against fit issues, measure the short and long pieces of your current best-fitting strap with a ruler and use those numbers if they differ from the recommendation.
Need a custom length not on the list? Pick the closest size and write your exact requirement in the Notes field at the bottom of the configurator — we cut to spec. The buckle has multiple holes, so being within a few millimeters of the calculator's recommendation is fine.
